The throttle connects to THRO channel (1)
The auxiliary connects to AUX2 channel (7)
Make sure that any mixing on AUX2 is off.
Activate the AUX2 switch in the [17.FUNC.S.]
menu.
ATV setup [12.TRAVEL]
Setup the throttle servo and linkage as close to
+/- 100% ATV as
possible.
Select the AUX2 channel to +100% and -100%
Hint: You can observe the AUX2 range on the [75.SERVO.M]
screen
The system is now ready for calibration. Calibration
Procedure
The target rotor speed can be calculated using
the ATV Calculator
Example 1): 2 speed setup:
Gear ratio = 9.3:1
ATV- = 39%, ATV+ = 72%
AUX2 Sw Posn Rotor
RPM
(DOWN)
1200
(UP) 1500
Example 2): 1 speed setup and disable:
Gear ratio = 9.3:1
ATV- = 0%, ATV+ = 72%
GEAR Sw Posn Rotor
RPM
(DOWN)
Disabled
(UP)
1500
Example 3): Flight Mode Mixing:
Set
the throttle curves in Flight modes 1 and 2 above the throttle priority level.
Set the AUX2 switch to the down position
Set the AUX2 ATV [TRVL ADJ] to -0%
Set the AUX2 switch to the up position
Set the AUX2 ATV [TRVL ADJ] to +100%
Perform the following mix setups with the AUX2 switch in the UP position.
[51.PGM.mix1] - This mix disables the Governor
in flight mode 'N'
AUX2->AUX2
NORM
OFFSET 0
-100% (Press the [TURN] to change the sign)
+0%
[page]
NR ACT and S1 ACT and S2 ACT
[52.PGM.mix2] - This mix sets the target rpm
to 1200rpm (39%) in flight mode '1'
AUX2->AUX2
NORM
OFFSET 0
+39%
+0%
[page]
S1 ACT only
[53.PGM.mix3] - This mix sets the target rpm
to 1500 (72%) in flight mode '2'
AUX2->AUX2
NORM
OFFSET 0
+72%
+0%
[page]
S2 ACT only
AUX2 Sw Posn Flight
Mode Rotor RPM
Down
N
Disabled
1
Disabled
2
Disabled
Up
N
Disabled
1
1200 rpm
2
1500rpm