The throttle connects to channel (3)
The auxiliary connects to AUX1 channel (7)
Endpoint setup [EPA]
Setup the throttle servo and linkage as close to
+/- 100% EPA as
possible..
Select channel 7 (AUX1) and set the [EPA] to +100% and -100%
The system is now ready for
calibration. Calibration Procedure
The target rotor speed can be calculated using
the EPA Calculator
Example 1): 2 position switch, single speed.
Select Channel 7
Select the Endpoint Adjust Menu [EPA]
With the switch in the up position, set the EPA to 74% (1500rpm
@ 9.3:1).
With the switch in the down position, set the EPA to 0%
AUX1 Switch Rotor RPM
Down
Disabled
Up
1500rpm
Example 2): 2 position switch, two speeds.
Select Channel 7
Select the Endpoint Adjust Menu [EPA]
With the switch in the up position, set the EPA to 74%
With the switch in the down position, set the EPA to 42%
AUX1 Switch Rotor RPM
@ 9.3:1
Down
1200rpm
Up
1500rpm
Example 3): Flight Mode Mixing:
After calibration, move the Auxiliary input to the GYRO channel
(Channel 5)
Select the [GYR] menu
Set F-Mode N to 0%
Set F-Mode 1 to 42% (1200rpm @ 9.3:1)
Set F-Mode 2 to 74% (1500rpm @ 9.3:1)
Set F-Mode 3 (Throttle Hold) to 0%
Yeilds the following setup:
Flight Mode
Rotor RPM
N
Disabled
1
1200rpm
2
1500rpm
3 (throttle hold) Disabled