Calibration
Procedure: |
________________________________________________________
|
1.
Put the
throttle stick and trim to the low position.
|
2.
Turn the
transmitter on and then the receiver.
(You will see a short blip of the yellow LED on the control box)
|
3.
Toggle the
auxiliary switch from high position to low position immediatly after you see the yellow LED on the TJ/RM blink, wait 2sec. and the
green LED will flash.
|
4.
Raise the
throttle high(yellow LED)and then low again(green LED).
|
5.
Toggle the
auxiliary switch back to high position, the green LED will turn off.
Calibration complete :-)
|
________________________________________________________
Home |